emerbrito

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • in reply to: Creating Rules #6504
    emerbrito
    Participant

    got it, thanks for your help 8)

    in reply to: Creating Rules #6502
    emerbrito
    Participant

    @SerpentFly wrote:

    This rule alows incoming connections (in case of TCP protocol) on the specified port. So it is applicable to both incoming and outgoing packets.

    I noticed you said “in case of TCP protocol”…
    So, let me see if i got it:

    If using TCP protocol, this rule will allow incoming and outgoing trafic.
    But what if i need the same kind of rule (incoming and outgoing) on the same port with UDP protocol? The rule would be the same?

    Or do i need one rule to alow incoming and another to alow outgoing trafic on the same port?

    in reply to: Creating Rules #6500
    emerbrito
    Participant

    @SerpentFly wrote:

    I assume that 192.168.1.1 is your local IP address? Is so the rule is just fine. However, please note that in order to allow FTP access you also need to open port 22.

    Hi,
    Well, i used this IP on this post just because i didn’t want to post the real one 😉
    About the port 22, i did create a rule alowing outgoing trafic on this port.

    But here is where i get confused:

    When i’m creating a rule for only incoming trafic i use:
    – Any Source to “My IP and Port”

    For only outgoing trafic i use:
    – “My IP and Port to any Destination”

    But how is the right way to create a rule to alow “incoming and outgoing” trafic on a specific port? The way i did on the first post?

    Thanks for your help.

Viewing 3 posts - 1 through 3 (of 3 total)