NeT Firewall 2.x Does Not Load Port Mapping on Startup

Home Forums Discussions Support Portal NeT Firewall 2.x Does Not Load Port Mapping on Startup

This topic contains 3 replies, has 3 voices, and was last updated by  Vadim Smirnov 9 years, 9 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #5175

    jpontius
    Participant

    I have enabled NeT Firewall to load on Windows startup. I have configured in the firewall, one port mapping. However, when Windows starts up, the port mapping is not functional. I have to run the MMC once before the port mappings are enabled. Once it has been run, I can close it and the port mapping persists, but it does not seem to enable the port mapping on boot up.

    Please help explain what I need to do in order for it to load the entire configuration, including port mappings, during Windows startup without having to login and run the console.

    Thank you.

    #6554

    Kon
    Participant

    Hi.

    Thank you for your report about port mapping. Please use the last version of NeT Firewall.

    #6555

    jpontius
    Participant

    Does this mean that it was a known bug in version 2.x and that it is fixed in the new version (3.x)?

    #6556

    Vadim Smirnov
    Moderator

    2.x firewall service loaded only filters and adapter modes, new features like port mappings were not supported. It was fixed in 3.x

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.